R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

135
Usage guidelines
T302 and T304 are timers for overlap sending. They are not available in overlap sending-incapable
ISDN protocols, including AT&T, NTT, NI2, and 5ESS.
Examples
# Set the T301 timer to 160 seconds on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn l3-timer t301 160
Related commands
• display isdn parameters
• isdn overlap-sending
isdn link-mode p2p
Use isdn link-mode p2p to configure a BRI interface to operate in point-to-point mode.
Use undo isdn link-mode to restore the default.
Syntax
isdn link-mode p2p
undo isdn link-mode
Default
A BRI interface operates in point-to-multipoint mode.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
The data link type of an ISDN BRI interface can be one of the following:
• point-to-point—The BRI interface can be connected only to one terminal device.
• point-to-multipoint—The BRI interface can be connected to multiple terminal devices.
Set the data link type of an ISDN BRI interface to be the same as its connected service provider switch.
If the isdn two-tei command is configured, the data link of the BRI interface must be point-to-multipoint.
You cannot change an ISDN BRI interface's data link type when a call is present.
Examples
# Configure BRI 2/4/0 to operate in point-to-point mode.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn link-mode p2p
Related commands
isdn two-tei