R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

141
[Sysname-Bri2/4/0] isdn number-property 0 called out
isdn overlap-sending
Use isdn overlap-sending to enable overlap sending on an ISDN interface for called numbers.
Use undo isdn overlap-sending to restore the default.
Syntax
isdn overlap-sending [ digits ]
undo isdn overlap-sending
Default
En-bloc sending is enabled for called numbers. In the SETUP message, ISDN includes all information
required by the network to process the call.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
digits: Specifies the maximum number of digits that can be sent in each SETUP message. The value range
is 1 to 15, and the default is 10.
Usage guidelines
In overlap mode, called number information is absent or incomplete in each outgoing SETUP message.
Overlap sending is not available in ANSI, DSS1, ETSI, NI, or QSIG.
You can execute this command only when no call is present on the ISDN interface.
Examples
# Enable overlap sending on BRI 2/4/0, and configure the interface to send a maximum of 12
called-number digits in each SETUP message.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn overlap-sending 12
isdn pri-slipwnd-size
Use isdn pri-slipwnd-size to set the sliding window size on an ISDN PRI interface.
Use undo isdn pri-slipwnd-size to restore the default.
Syntax
isdn pri-slipwnd-size window-size
undo isdn pri-slipwnd-size
Default
The sliding window size is 7 on ISDN PRI interfaces.