R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

148
Default
NIT mode is disabled. NI-enabled BRI interfaces perform dynamic SPID negotiation.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
This command is available only on NI-enabled BRI interfaces.
Typically, an NI-enabled BRI interface must pass SPID negotiation or initiation before it can place a call.
You must enable Not Initial Terminal (NIT) mode on the BRI interface if the NI-type service provider switch
does not support SPID negotiation.
You can configure this command only when no call or SPID negotiation is present on the BRI interface.
Examples
# Enable NIT mode on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn spid nit
Related commands
display isdn spid
isdn spid resend
Use isdn spid resend to set the maximum number of INFORMATION message retransmissions for SPID
negotiation or initialization on an NI-enabled BRI interface.
Use undo isdn spid resend to restore the default.
Syntax
isdn spid resend times
undo isdn spid resend
Default
The number of INFORMATION message retransmission attempts is 1.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Parameters
times: Specifies the maximum number of INFORMATION message retransmissions, in the range of 1 to
255.
Usage guidelines
This command is available only on NI-enabled BRI interfaces.