R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

157
Views
PVC view, PVC-group view
Predefined user roles
network-admin
Usage guidelines
With the broadcast attribute enabled, a PVC or PVC-group can receive the broadcast or multicast
packets sent on the ATM interface.
You must configure this command on a PVC or PVC-group where broadcast or multicast packets must be
sent. For example, to establish PIM neighbors between two routers on an ATM link through exchanging
IP multicast packets, you must enable the broadcast attribute for PVCs on the ATM interfaces of both ends
on the link.
This command is not applicable to PVCs in a PVC-group.
Examples
# Enable the broadcast attribute for PVC 0/100.
<Sysname> system-view
[Sysname] interface atm 2/4/1.1
[Sysname-ATM2/4/1.1] pvc 0/100
[Sysname-ATM2/4/1.1-pvc-0/100] broadcast
default
Use default to restore the default settings for an interface.
Syntax
default
Views
VE interface view, VE subinterface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you use it in a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies or system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings of VE interface Virtual-Ethernet 2/4/1.
<Sysname> system-view
[Sysname] interface virtual-ethernet 2/4/1