R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

176
default: Sets the default PVC mapping. If no PVC mapping can be found for the next hop address of a
packet, the packet is sent through the default PVC or PVC-group.
inarp: Enables InARP on the PVC.
minutes: Specifies the interval for sending InARP packets, in the range of 1 to 600 minutes. The default
is 15 minutes.
Usage guidelines
All encapsulations support IPoA. Only aal5snap supports InARP. You cannot configure InARP when
aal5mux or aal5nlpid is used.
A PVC or PVC-group can be configured with multiple IP address mappings, including static IP address
mapping, default mapping, and InARP mapping.
Different PVCs or PVC-groups on the same interface cannot be mapped to the same IP address.
The PVCs or PVC-groups on the same interface can be configured with only one default mapping.
If you do not specify any argument or keyword, the undo map ip command deletes all static IP address
mappings, default mappings, and InARP mappings on the PVC or PVC-group.
This command is not applicable to PVCs in a PVC-group.
Examples
# Create a static IP address mapping on PVC 1/32, and specify the IP address of the remote end as
61.123 .3 0 .16 9.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/32
[Sysname-ATM2/4/0-pvc-1/32] map ip 61.123.30.169
# Enable InARP mapping on PVC 1/33, and specify the InARP packet sending interval as 10 minutes.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/33
[Sysname-ATM2/4/0-pvc-1/33] map ip inarp 10
# Delete all IP address mappings on PVC 1/33.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/33
[Sysname-ATM2/4/0-pvc-1/33] undo map ip
Related commands
encapsulation
map ppp
Use map ppp to create a PPPoA mapping for a PVC or PVC-group.
Use undo map ppp to delete the mapping.
Syntax
map ppp virtual-template vt-number
undo map ppp