R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

206
# Set the description to Cellular-intf for Cellular 2/0/0.
<Sysname> system-view
[Sysname] controller cellular 2/0/0
[Sysname-Cellular2/0/0] description Cellular-intf
display cellular
Use display cellular to display call connection information for a 3G/4G modem.
Syntax
display cellular [ cellular-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
cellular-number: Specifies a cellular interface by its number. If no cellular interface is specified, call
connection information for all cellular interfaces with 3G/4G modems installed is displayed.
Usage guidelines
The command output might vary by modems of different manufacturers.
Examples
# Display call connection information for Cellular 2/0/0 (WCDMA network).
<Sysname> display cellular 2/0/0
Cellular2/0/0:
Hardware Information:
Model: E176G
Modem Firmware Version: 11.604.09.00.00
Hardware Version: CD25TCPU
International Mobile Subscriber Identity (IMSI): 460029010431055
International Mobile Equipment Identity (IMEI): 353871020138548
Factory Serial Number (FSN): DK9RAA1871500602
Modem Status: Online
Profile Information:
Profile 1: Active
PDP Type: IPv4, Header Compression: Off
Data Compression: Off
Access Point Name (APN): 001
Packet Session Status: Inactive
Modem Setup Information:
Diagnostics Monitor: Close
Network Information:
Current Service Status: Service available
Current Service: Combined
Packet Service: Attached