R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

223
If a card is locked, the 3G modem cannot be used. To unlock the card, you can use the pin unlock
command. The new PIN is saved on the SIM/UIM card.
If PIN verification is enabled, use the pin verify command to save the new PIN on the device after the
SIM/UIM card is unlocked.
If you consecutively fail to unlock a card by using the PUK, the card will be locked permanently. To unlock
a permanently locked card, contact the service provider of the card.
Examples
# Use the PUK to unlock a SIM/UIM card.
<Sysname> system-view
[Sysname] controller cellular 2/0/0
[Sysname-Cellular2/0/0] pin unlock 87654321 1234
PIN will be unlocked and changed to 1234. Continue? [Y/N]:y
PIN has been unlocked and changed successfully.
Related commands
• pin modify
• pin verification enable
pin verification enable
Use pin verification enable to enable PIN verification for a 3G/4G modem.
Use undo pin verification enable to disable PIN verification for a 3G/4G modem.
Syntax
pin verification enable [ pin ]
undo pin verification enable [ pin ]
Default
The default setting for this command depends on the modem model.
Views
Cellular interface view
Predefined user roles
network-admin
Parameters
pin: Specifies the PIN of the SIM/UIM card, a string of 4 to 8 digits.
Usage guidelines
If PIN verification is enabled, PIN verification is performed after you perform any of the following
operations:
• Install a 3G/4G modem.
• Reboot the device where a USB 3G/4G modem is attached.
• Execute the modem reboot command to reboot a 3G/4G modem.
• Hot swap a USB 3G/4G modem.
• Cold boot the device where a SIC-3G/4G modem is installed.