R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

243
Default
Bundle DDR is disabled on a dialer interface.
Views
Dialer interface view
Predefined user roles
network-admin
Usage guidelines
DDR includes traditional DDR and bundle DDR.
Before using bundle DDR, use this command to enable bundle DDR on a dialer interfac. Then assign
physical interfaces to the corresponding dialer bundle by using the dialer bundle-member command. To
enable bundle DDR to receive calls, configure the dialer peer-name command on the dialer interface.
If you configure this command on a dialer interface already enabled with traditional DDR, the system
clears the original traditional DDR settings.
The undo dialer bundle enable command clears all bundle DDR settings on a dialer interface.
Examples
# Enable bundle DDR on interface Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer bundle enable
Related commands
• dialer bundle-member
• dialer circular enable
• dialer peer-name
dialer bundle-member
Use dialer bundle-member to assign a physical interface to a dialer bundle in bundle DDR.
Use undo dialer bundle-member to remove a physical interface from a dialer bundle.
Syntax
dialer bundle-member number [ priority priority ]
undo dialer bundle-member number
Default
A physical interface does not belong to any dialer bundle.
Views
Physical interface view
Predefined user roles
network-admin
Parameters
number: Specifies a dialer bundle by its number, which must be the same as the dialer interface number.