R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

249
Examples
# Set the interval for DDR to collect traffic statistics to 3 seconds.
<Sysname> system-view
[Sysname] dialer flow-interval 3
Related commands
dialer threshold
dialer number
Use dialer number to configure a dial string for placing calls to a single remote site.
Use undo dialer number to remove the configured dial string.
Syntax
dialer number dial-number [ autodial ]
undo dialer number
Default
No dial string is configured for calling the remote site.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
dial-number: Specifies a dial string for calling a remote site, a case-insensitive string of 1 to 30
characters.
autodial: Enables the device to automatically dial the remote site by using the specified dial string at
specified intervals. The interval is set in the dialer timer autodial command and defaults to 300 seconds.
Usage guidelines
You must configure this command when the dialer or physical interface is the calling party.
In traditional DDR, you can also use the dialer route command to configure multiple destination
addresses or dial strings. However, in bundle DDR, you can only use the dialer number command to
configure one dial string for each dialer interface. This is because associations between dialer interfaces
and call destination address are one-to-one.
Examples
# Set the dial string for placing calls to 11111 on interface Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer number 11111
Related commands
• dialer route
• dialer timer autodial