R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

258
Examples
# Set the wait-carrier timer to 100 seconds on interface Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer timer wait-carrier 100
dialer timer warmup
Use dialer timer warmup to configure the warm-up timer for dynamic route backup.
Use undo dialer timer warmup to restore the default.
Syntax
dialer timer warmup delay
undo dialer timer warmup
Default
The warm-up timer is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
delay: Specifies the warm-up timer value for dynamic route backup, in the range of 0 to 65535 seconds.
Usage guidelines
The warm-up timer starts upon system boot. Before it expires, the dynamic route backup function is
disabled. The system cannot dial a secondary link even if the corresponding primary link is down. If the
primary link has not gone up when the timer expires, the system dials the secondary link. After the
primary link goes up, the system switches over to it.
Examples
# Set the warm-up timer to 20 seconds for dynamic route backup.
<Sysname> system-view
[Sysname] dialer timer warmup 20
dialer-group
Use dialer-group to assign a dialup interface to a dialer group.
Use undo dialer-group to restore the default.
Syntax
dialer-group group-number
undo dialer-group
Default
A dialup interface does not belong to any dialer group.