R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

263
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Dia1 ADM Administratively
Table 52 Command output
Field Descri
p
tion
Dialer1
Current state
Physical state of the dialer interface:
• UP—The dialer interface is physically up.
• DOWN (Administratively)—The dialer interface was shut down with the
shutdown command. To re-enable it, you must use the undo shutdown
command on it.
Line protocol state Data link layer protocol state of the dialer interface: UP or DOWN.
Description Interface description.
Bandwidth Intended bandwidth of the interface.
Maximum Transmit Unit MTU of the dialer interface.
Internet protocol processing Network layer protocol state of the dialer interface.
LCP: initial LCP initialization is complete.
Physical Physical interface type.
Output queue - Urgent queuing Statistics on the packets in the urgent output queue.
Output queue - Protocol queuing Statistics on the packets in the protocol output queue.
Output queue - FIFO queuing Statistics on the packets in the FIFO output queue.
Size Number of packets in the queue.
Length Queue length.
Discards Number of discarded packets.
Last clearing of counters: Never
Time when statistics on the dialer interfaces were last cleared. Never
indicates the statistics were never cleared.
Last 300 seconds input rate Input interface data rate during the latest 300 seconds.
Last 300 seconds output rate Output interface data rate during the latest 300 seconds.
Input: 0 packets, 0 bytes, 0
dropped
Statistics on the packets reaching the interface.
Output: 0 packets, 0 bytes, 0
dropped
Statistics on the packets sent through the interface.
Brief information on interface(s)
under route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively
down; Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To recover its
physical state, execute the undo shutdown command.
• Stby—The interface is operating as a standby interface. To display the
active interface, use the display interface-backup state command (High
Availability Command Reference).
Protocol: (s) - spoofing
If the data link layer protocol state of an interface is shown as UP, but its link
is an on-demand link or not present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).