R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

28
VA1 DOWN Not connected
Table 4 Command output
Field Descri
p
tion
Virtual-Access1
Current state
Physical and administrative states of the interface:
• DOWN—The interface is administratively up but physically down.
• UP—The interface is both administratively and physically up.
Line protocol state Data link layer state: UP or DOWN.
Description Interface description.
Bandwidth Expected bandwidth of the interface.
Hold timer Interval at which the interface sends keepalive packets.
Internet Address is 122.1.1.1/24
Primary
IP address of the interface.
If the VT interface is not configured with an IP address, this field
displays Internet protocol processing: disabled.
LCP: opened, MP: opened, IPCP:
opened
The PPP connection has been successfully established.
Physical Physical type of the interface.
Main interface
Primary interface for which VA interfaces are created. It can be a VT
interface or dialer interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Traffic statistics of the interface output queues.
Last clearing of counters: Never
Last time when statistics on the interface were cleared. Never
indicates that statistics on the interface were never cleared.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
Input: 2 packets, 24 bytes, 0 drops
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the inbound packets.
Output: 2 packets, 24 bytes, 0 drops
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the outbound packets.
Brief information on interface(s) under
route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
• Stby—The interface is a backup interface. To see the primary
interface, use the display interface-backup state command in
High Availability Command Reference.