R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

31
Field Descri
p
tion
Hold timer Interval at which the interface sends keepalive packets.
Internet protocol processing
Network layer state of the interface:
• enabled—The interface is not configured with an IP address and
cannot process IP packets.
• Internet Address—The interface is configured with an IP address.
LCP initial LCP negotiation is complete.
Physical Physical type of the interface.
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0)
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0)
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0)
Traffic statistics of the interface output queues.
Brief information on interface(s) under
route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see the
primary interface, use the display interface-backup state
command in High Availability Command Reference.
Protocol: (s) - spoofing
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Interface Abbreviated interface name.
Link
Physical link state of the interface. This field for a VT interface can
only be DOWN.
Protocol
Line protocol state of the interface. This field for a VT interface can
only be DOWN.
Main IP Primary IP address of the interface.
Description
Interface description configured by using the description command.
Without the description keyword, the display interface brief
command displays at most 27 characters of the description. With the
description keyword, this command displays the complete
description.
Cause
Causes for the physical state of the interface to be Down.
Not connected indicates no physical link exists (possibly because the
network cable is disconnected or faulty).
display ppp mp
Use display ppp mp to display MP information for MP-group interfaces.
Syntax
display ppp mp [ interface interface-type interface-number ]