R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

121
Multiple IP addresses can be mapped to the same PVC or PVC-group. You can configure static IP
mapping, default mapping, and InARP mapping at the same time. Different PVCs or PVC-groups on
the same interface cannot be mapped to the same IP address. The PVCs or PVC-groups on the same
interface can be configured with only one default mapping.
If the interfaces of two routers are connected back-to-back, the local PVC mapped to the remote IP
address must have the same VPI/VCI value as the remote PVC mapped to the local IP address.
To configure IPoA:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter ATM interface
view or ATM
subinterface view.
interface atm { interface-number |
interface-number.subnumber }
N/A
3. Enter PVC view or
PVC-group view.
Enter PVC view:
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
Enter PVC-group view:
pvc-group group-number
Use either method.
4. Configure an IPoA
mapping to enable the
PVC or PVC-group to
carry IP packets.
map ip { ip-address | default |
inarp [ minutes ] }
By default, no mapping is configured.
5. (Optional.) Enable the
broadcast attribute for
the PVC or PVC-group.
broadcast
By default, the broadcast attribute is
disabled.
With the broadcast attribute enabled, the
PVC or PVC-group can receive the
broadcast or multicast packets sent on the
ATM interface.
You must configure this command on a
PVC or PVC-group where broadcast or
multicast packets must be sent.
Configuring IPoEoA
Follow these guidelines when you configure IPoEoA:
In an IPoEoA application, configure the IP address for VE interfaces instead of ATM interfaces. The
IP address configuration does not take effect on ATM interfaces.
In an IPoEoA application, configure Class Based Queuing (CBQ) on PVCs or PVC-groups.
Perform this task to enable a PVC or PVC-group to carry Ethernet packets.
To configure IPoEoA:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create a VE
interface.
interface virtual-ethernet interface-number N/A