R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

To configure the polling interval:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter interface view.

interface interface-type interface-number N/A

3. Configure the polling

interval.

timer-hold period The default setting is 10 seconds.

Configuring PPP negotiation

PPP negotiation parameters that can be configured are as follows:

• Negotiation timeout time

• IP address negotiation

• DNS server IP address negotiation

• ACCM negotiation

• ACFC negotiation

• PFC negotiation

Configuring the PPP negotiation timeout time

During PPP negotiation, if no response is received from the peer during a specific period after the local

device sends a packet, the device sends the packet again. The period is known as negotiation timeout

time, which is in the range of 1 to 10 seconds.

To configure the PPP negotiation timeout time:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter interface view.

interface interface-type

interface-number

N/A

3. Configure the negotiation

timeout time.

ppp timer negotiate seconds The default setting is 3 seconds.

Configuring IP address negotiation

The device can perform IP address negotiation during IPCP negotiation. Through IP address negotiation,

one end can assign an IP address to the other.

IP address negotiation can be implemented in the following modes:

• The device operating as the client—This mode applies when a local interface uses PPP as its link

layer protocol but does not have an IP address, while the peer is configured with an IP address. In

this mode, the interface accepts an IP address allocated by its peer. This mode is used for situations

where a device accesses the Internet through an ISP, which assigns an IP address to the device.

• The device operating as the server—In this mode, you assign an IP address to the peer and

configure an IP address for the local device in interface view.

When IP address negotiation is enabled on a client, the server selects an IP address for the client in the

following sequence: