R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

160
Ste
p
Command Remarks
3. Enable traditional DDR.
dialer circular enable
By default, traditional DDR is
disabled.
4. Configure a dial string.
• dialer number dial-number
• dialer route ip
next-hop-address [ mask
network-mask-length ]
[ vpn-instance
vpn-instance-name ]
dial-number [ broadcast ]
Use either command.
By default, no dial string is
configured.
To configure an interface to place calls through a dialer circular group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable traditional DDR on the
interface.
dialer circular enable
By default, traditional DDR is
disabled on an interface.
4. Configure a dial string.
• dialer number dial-number
• dialer route ip
next-hop-address [ mask
network-mask-length ]
[ vpn-instance
vpn-instance-name ]
dial-number [ interface
interface-type
interface-number ] [ broadcast ]
Use either command.
By default, no dial string is
configured.
5. Return to system view.
quit N/A
6. Enter physical interface view.
interface interface-type
interface-number
N/A
7. Assign the physical interface to
the specified dialer circular
group.
dialer circular group number
By default, a physical interface
does not belong to any dialer
circular group.
Make sure the number arguments
in the interface dialer and dialer
circular group commands use the
same value.