R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

163
Ste
p
Command Remarks
6. Enter physical interface view.
interface interface-type
interface-number
N/A
7. Assign the physical interface to
the specified dialer bundle.
dialer bundle-member number
[ priority priority ]
By default, a physical interface
does not belong to any dialer
bundle.
Make sure the number arguments
in the interface dialer and dialer
bundle-member commands use
the same value.
Configuring a dialer interface to receive calls
To configure a dialer interface to receive calls, you only need to enable DDR on the interface. You do not
need to configure dial strings. At the receiving end, you need to configure PAP or CHAP authentication
(see "Configuring PPP and MP") on the physical interface and the dialer peer-name command on the
dialer interface.
To configure an interface to receive calls:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a dialer interface and
enter its view.
interface dialer number N/A
3. Enable bundle DDR on the
interface.
dialer bundle enable
By default, bundle DDR is
disabled.
4. Configure the host name of the
remote router.
dialer peer-name username
The router checks the remote
username obtained in PPP
authentication against the
configured host names to
determine which dialer interface
receives which call.
You can configure a maximum
number of 255 host names for a
dialer interface. This enables one
dialer interface to receive calls
from multiple physical interfaces.
5. Return to system view.
quit N/A
6. Enter physical interface view.
interface interface-type
interface-number
N/A
7. Assign the physical interface to
the specified dialer bundle.
dialer bundle-member number
[ priority priority ]
By default, a physical interface
does not belong to any dialer
bundle.
Make sure the number arguments
in the interface dialer and dialer
bundle-member commands use
the same value.