R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

205

Figure 63 Network diagram

Configuration procedure

1. Configure Router A:

# Create dialer group 1 and configure a dial rule for it. Create a local user userb for Router B, and

configure the service type as PPP.

<RouterA> system-view

[RouterA] dialer-group 1 rule ip permit

[RouterA] local-user userb class network

[RouterA-luser-network-userb] password simple userb

[RouterA-luser-network-userb] service-type ppp

[RouterA-luser-network-userb] quit

# Create a dynamic route backup group.

[RouterA] standby routing-group 1 rule ip 30.0.0.1 32

# Configure bundle DDR on interface Dialer 0.

[RouterA] interface dialer 0

[RouterA-Dialer0] link-protocol ppp

[RouterA-Dialer0] ip address 20.0.0.1 24

[RouterA-Dialer0] dialer bundle enable

[RouterA-Dialer0] dialer peer-name userb

[RouterA-Dialer0] dialer-group 1

[RouterA-Dialer0] dialer number 8810052

[RouterA-Dialer0] ppp authentication-mode pap

[RouterA-Dialer0] ppp pap local-user usera password simple usera

[RouterA-Dialer0] standby routing-group 1

[RouterA-Dialer0] quit

# Assign interface BRI 2/4/0 to Dialer 0.

[RouterA] interface bri 2/4/0

[RouterA-Bri2/4/0] dialer bundle-member 0

[RouterA-Bri2/4/0] ppp authentication-mode pap

[RouterA-Bri2/4/0] ppp pap local-user usera password simple usera

[RouterA-Bri2/4/0] quit

# Enable PPP on interface Serial 2/1/0.

[RouterA] interface serial 2/1/0

[RouterA-Serial2/1/0] link-protocol ppp

[RouterA-Serial2/1/0] ip address 10.0.0.1 8