R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

208
[RouterA-E1 2/3/1] quit
# Configure PPP encapsulation on interface Serial 2/1/0.
[RouterA] interface serial 2/1/0
[RouterA-Serial2/1/0] ip address 1.0.0.1 255.0.0.0
[RouterA-Serial2/1/0] link-protocol ppp
[RouterA-Serial2/1/0] quit
# Configure traditional DDR on the PRI interface.
[RouterA] interface serial 2/3/1:15
[RouterA-Serial2/3/1:15] ip address 2.0.0.1 255.0.0.0
[RouterA-Serial2/3/1:15] dialer circular enable
[RouterA-Serial2/3/1:15] dialer-group 1
[RouterA-Serial2/3/1:15] dialer route ip 10.0.0.0 mask 8 660220
[RouterA-Serial2/3/1:15] standby routing-group 1
[RouterA-Serial2/3/1:15] quit
# Configure RIP.
[RouterA] rip
[RouterA-rip-1] network 1.0.0.0
[RouterA-rip-1] network 2.0.0.0
[RouterA-rip-1] import-route direct
# Configure the routes used by the serial interface to adopt higher priorities than those used by the
dialup interface.
[RouterA] interface serial 2/3/1:15
[RouterA-Serial2/3/1:15] rip metricin 2
2. Configure Router B:
# Create dialer group 1 and configure a dial rule for it.
[RouterB] system
[RouterB] dialer-group 1 rule ip permit
# Bundle timeslots on the CE1 interface into a PRI group.
[RouterB] controller e1 2/3/1
[RouterB-E1 2/3/1] pri-set
[RouterB-E1 2/3/1] quit
# Configure PPP encapsulation on interface Serial 2/1/0.
[RouterB] interface serial 2/1/0
[RouterB-Serial2/1/0] ip address 1.0.0.2 255.0.0.0
[RouterB-Serial2/1/0] link-protocol ppp
[RouterB-Serial2/1/0] quit
# Configure traditional DDR on PRI interface Serial 2/3/1:15.
[RouterB] interface serial 2/3/1:15
[RouterB-Serial2/3/1:15] ip address 2.0.0.2 255.0.0.0
[RouterB-Serial2/3/1:15] dialer circular enable
[RouterB-Serial2/3/1:15] dialer-group 1
[RouterB-Serial2/3/1:15] dialer route ip 2.0.0.1 mask 8 660330
[RouterB-Serial2/3/1:15] quit
# Configure the Ethernet interfaces connecting to the networks.
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] ip address 10.0.0.1 255.0.0.0