R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

16
When you configure MP by using a VT interface, follow these guidelines:
• The ppp mp command and the ppp mp virtual-template command are mutually exclusive on an
interface.
• You must use the same method to configure the interfaces to be bundled .
• To use one-way authentication, associate physical interfaces to a VT interface on one end and
associate a username to the VT interface on the other end.
• Configure a VT interface to provide only one service, such as MP, L2TP, or PPPoE.
Configuring MP by using a VT interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VT interface and enter
its view.
interface virtual-template number
If the VT interface already
exists, you enter its view
directly.
3. (Optional.) Set the interface
description.
description text
By default, the description of
a VT interface is interface
name Interface, for example,
Virtual-Template1 Interface.
4. Set the polling interval.
timer-hold period
The default setting is 10
seconds.
5. Set the MTU size of the interface.
mtu size
The default setting is 1500
bytes.
6. Set the expected bandwidth of
the VT interface.
bandwidth bandwidth-value
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided
by 1000.
7. (Optional.) Specify a card to
forward traffic for the VA
interfaces of the VT interface
(MSR4000).
service slot slot-number
By default, no card is
specified.
8. (Optional.) Restore the default
settings for the VT interface.
default N/A
9. Return to system view.
quit N/A