R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

56 bytes from 200.1.1.1: icmp_seq=0 ttl=128 time=3.197 ms

56 bytes from 200.1.1.1: icmp_seq=1 ttl=128 time=2.594 ms

56 bytes from 200.1.1.1: icmp_seq=2 ttl=128 time=2.739 ms

56 bytes from 200.1.1.1: icmp_seq=3 ttl=128 time=1.738 ms

56 bytes from 200.1.1.1: icmp_seq=4 ttl=128 time=1.744 ms

--- Ping statistics for 200.1.1.1 ---

5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss

round-trip min/avg/max/std-dev = 1.738/2.402/3.197/0.576 ms

The output shows that the ping operation is successful.

# Display the address pool aaa on Serial 2/1/0 of Router A.

[RouterA-Serial2/1/0] display ip pool aaa

Group name: AAA

Pool name Start IP address End IP address Free In use

aaa 200.1.1.10 200.1.1.20 10 1

In use IP addresses:

IP address Interface

200.1.1.10 S2/1/0

The output shows that one IP address has been assigned.

Using the address pool associated with an ISP domain

Network requirements

As shown in Figure 8, configure Router A to allocate an IP address from the address pool associated with

the ISP domain to Serial 2/1/0 of Router B through PPP negotiation.

Figure 8 Network diagram

Configuration procedure

1. Configure Router A:

# Configure an address pool aaa that contains IP addresses 200.1.1.10 through 200.1.1.20 for

the group AAA.

<RouterA> system-view

[RouterA] ip pool aaa 200.1.1.10 200.1.1.20 group AAA

# Create a local user for Router B.

[RouterA] local-user userb class network

# Set a password for the local user.

[RouterA-luser-network-userb] password simple 123

# Set the service type to PPP for the local user.

[RouterA-luser-network-userb] service-type ppp

[RouterA-luser-network-userb] quit

# Create an ISP domain bbb and associate the address pool aaa with bbb.

[RouterA] domain bbb