R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

200.1.1.10 S2/1/0

The output shows that one IP address of the address pool aaa has been assigned.

MP binding mode configuration examples

Network requirements

As shown in Figure 9, to enable MP for Serial 2/1/0 and Serial 2/1/1, use one of the following

methods:

• Bind the physical interfaces to a VT interface.

• Associate remote usernames with a VT interface.

• Configure an MP-group interface.

Figure 9 Network diagram

Configuration procedure

(Method 1) Bind the physical interfaces to a VT interface.

1. Configure Router A:

# Create a VT interface, and configure an IP address for it.

<RouterA> system-view

[RouterA] interface virtual-template 1

[RouterA-Virtual-Template1] ip address 8.1.1.1 24

[RouterA-Virtual-Template1] quit

# Configure Serial 2/1/1.

[RouterA] interface serial 2/1/1

[RouterA-Serial2/1/1] link-protocol ppp

[RouterA-Serial2/1/1] ppp mp virtual-template 1

[RouterA-Serial2/1/1] quit

# Configure Serial 2/1/0.

[RouterA] interface serial 2/1/0

[RouterA-Serial2/1/0] link-protocol ppp

[RouterA-Serial2/1/0] ppp mp virtual-template 1

[RouterA-Serial2/1/0] quit

2. Configure Router B:

# Create a VT interface, and configure an IP address for it.

<RouterB> system-view

[RouterB] interface virtual-template 1

[RouterB-Virtual-Template1] ip address 8.1.1.2 24

[RouterB-Virtual-Template1] quit

# Configure Serial 2/1/1.

[RouterB] interface serial 2/1/1

[RouterB-Serial2/1/1] link-protocol ppp

[RouterB-Serial2/1/1] ppp mp virtual-template 1