R0106-HP MSR Router Series Layer 2 - WAN Configuration Guide(V7)

[RouterB-Dialer1] ip address ppp-negotiate

# Configure a PPPoE session that corresponds to dialer bundle 1 (dialer bundle 1 corresponds to

Dialer 1).

[RouterB] interface gigabitethernet 1/0/1

[RouterB-GigabitEthernet1/0/1] pppoe-client dial-bundle-number 1

[RouterB-GigabitEthernet1/0/1] quit

# Configure the PPPoE session to operate in diagnostic mode, and set the diagnostic interval to

200 seconds.

[RouterB] interface dialer 1

[RouterB-Dialer1] dialer diagnose interval 200

# Set the DDR auto-dial interval to 10 seconds.

[RouterB-Dialer1] dialer timer autodial 10

3. Verify the configuration by displaying summary information about the PPPoE session established

between Router B and Router A (PPPoE server).

[RouterB-Dialer1] display pppoe-client session summary

Bundle ID Interface VA RemoteMAC LocalMAC State

1 1 GE1/0/1 VA0 00e0-1400-4300 00e0-1500-4100 SESSION

Configuration example for connecting a LAN to the Internet

through an ADSL modem

Network requirements

As shown in Figure 16:

• Router A provides Internet access for Host A, Host B, and Host C. It connects to the DSLAM through

an ADSL modem and a permanent PPPoE session.

• The username and password of the ADSL account are user1 and 123456 .

• Router A operates as a PPPoE client, and it allows the hosts in the LAN to access the Internet without

PPPoE client software.

• Router B operates as the PPPoE server. It performs RADIUS authentication and accounting.