R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

102
FRR backup: Enabled
Enabled by network configuration
Table 23 Command output
Field Descri
p
tion
OSPF Process 1 with Router ID 192.168.1.2 OSPF process ID and OSPF router ID.
RouterID Router ID.
Router type
Router type:
• ABR.
• ASBR.
• NSSA.
• Null.
Route tag Tag of redistributed routes.
Multi-VPN-Instance is not enabled The OSPF process does not support multi-VPN-instance.
Ext-community type
OSPF extended community attribute type codes:
• domain ID—Domain ID code.
• router type—Router type code.
• router ID—Router ID code.
Domain ID OSPF domain ID (primary ID).
Opaque capable
Opaque LSA advertisement and reception capability is
enabled.
Originating router-LSAs with maximum
metric
The maximum cost value for router LSAs (excluding stub links) is
used.
Condition
Status of the stub router:
• Always.
• On startup while BGP is converging.
• On startup while BGP is converging for XXX seconds.
• On startup for XXX seconds.
State Indicates whether the stub router is active.
SPF-schedule-interval Interval for SPF calculations.
LSA generation interval LSA generation interval.
LSA arrival interval LSA arrival interval.
Transmit pacing
LSU packet transmit rate of the interface:
• Interval—LSU transmit interval of the interface.
• Count—Maximum number of LSU packets sent at each
interval.
Default ASE parameters Default ASE parameters: metric, tag, and route type.
Route preference Internal route preference.
ASE route preference External route preference.
SPF computation count SPF computation count of the OSPF process.
RFC1583 compatible Compatible with RFC 1583.
SNMP trap rate limit interval SNMP notification sending interval.