R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

157
network (OSPF area view)
Use network to enable OSPF on the interface attached to the specified network in the area.
Use undo network to disable OSPF for the interface attached to the specified network in the area.
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
Default
OSPF is not enabled for any interface.
Views
OSPF area view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of a network.
wildcard-mask: Specifies the wildcard mask of the IP address. For example, the wildcard mask of mask
255.0.0.0 is 0.255.255.255.
Usage guidelines
This command enables OSPF on the interface attached to the specified network. The interface's primary
IP address must be in the specified network. If only the interface's secondary IP address is in the network,
the interface cannot run OSPF.
Examples
# Specify the interface whose primary IP address is on network 131.108.20.0/24 to run OSPF in Area 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 2
[Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255
Related commands
ospf
non-stop-routing
Use non-stop-routing to enable OSPF NSR.
Use undo non-stop-routing to disable OSPF NSR.
Syntax
non-stop-routing
undo non-stop-routing
The following matrix shows the support of MSR routers for the command: