R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

172
Examples
# Set the poll timer interval on GigabitEthernet 2/1/1 to 130 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] ospf timer poll 130
Related commands
ospf timer hello
ospf timer retransmit
Use ospf timer retransmit to set the LSA retransmission interval on an interface.
Use undo ospf timer retransmit to restore the default.
Syntax
ospf timer retransmit interval
undo ospf timer retransmit
Default
The LSA retransmission interval is 5 seconds on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Specifies the LSA retransmission interval in the range of 1 to 3600 seconds.
Usage guidelines
After sending an LSA, an interface waits for an acknowledgement packet. If the interface receives no
acknowledgement within the retransmission interval, it retransmits the LSA.
To avoid unnecessary retransmissions, set an appropriate retransmission interval. For example, you can
set a large retransmission interval value on a low-speed link.
Examples
# Set the LSA retransmission interval to 8 seconds on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] ospf timer retransmit 8
ospf trans-delay
Use ospf trans-delay to set the LSA transmission delay on an interface.
Use undo ospf trans-delay to restore the default.
Syntax
ospf trans-delay seconds
undo ospf trans-delay