R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

182
undo snmp trap rate-limit
Default
OSPF outputs up to seven SNMP notifications within 10 seconds.
Views
OSPF view
Predefined user roles
network-admin
Parameters
trap-interval: Specifies the SNMP notification output interval in the range of 1 to 60 seconds.
trap-number: Specifies the number of SNMP notifications output by OSPF at each interval, in the range
of 0 to 300.
Examples
# Configure OSPF to output up to 10 SNMP notifications within 5 seconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] snmp trap rate-limit interval 5 count 10
snmp-agent trap enable ospf
Use snmp-agent trap enable ospf to enable SNMP notifications for OSPF.
Use undo snmp-agent trap enable ospf to disable the feature.
Syntax
snmp-agent trap enable ospf [ authentication-failure | bad-packet | config-error |
grhelper-status-change | grrestarter-status-change | if-state-change | lsa-maxage | lsa-originate |
lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change |
retransmit | virt-authentication-failure | virt-bad-packet | virt-config-error | virt-retransmit |
virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] *
undo snmp-agent trap enable ospf [ authentication-failure | bad-packet | config-error |
grhelper-status-change | grrestarter-status-change | if-state-change | lsa-maxage | lsa-originate |
lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change |
retransmit | virt-authentication-failure | virt-bad-packet | virt-config-error | virt-retransmit |
virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] *
Default
SNMP notifications for OSPF is enabled.
Views
System view
Predefined user roles
network-admin
Parameters
authentication-failure: Specifies notifications about authentication failures on an interface.
bad-packet: Specifies notifications about error messages received on an interface.