R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

245
Syntax
isis [ process-id ] [ vpn-instance vpn-instance-name ]
undo isis [ process-id ]
Default
The system does not run any IS-IS process.
Views
System view
Predefined user roles
network-admin
Parameters
process-id: Specifies an IS-IS process by its ID in the range of 1 to 65535. The default is 1.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If no VPN is specified, the IS-IS process runs on the public network.
Examples
# Enable IS-IS process 1 and specify the system ID as 0000.0000.0002 and area ID as 01.0001.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] network-entity 01.0001.0000.0000.0002.00
Related commands
• isis enable
• network-entity
isis authentication send-only
Use isis authentication send-only to configure an IS-IS interface not to check the authentication
information in the received hello packets.
Use undo isis authentication send-only to remove the configuration.
Syntax
isis authentication send-only [ level-1 | level-2 ]
undo isis authentication send-only [ level-1 | level-2 ]
Default
When interface authentication mode and password are configured, an IS-IS interface checks the
authentication information in the received packets.
Views
Interface view
Predefined user roles
network-admin
Parameters
level-1: Configures IS-IS not to check the authentication information in the received Level-1 hello packets.