R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

250
undo isis cost [ level-1 | level-2 ]
Default
No IS-IS cost is configured for an interface.
Views
Interface view, IPv4 unicast topology view
Predefined user roles
network-admin
Parameters
value: Specifies an IS-IS cost in the range of 1 to 16777215.
level-1: Applies the cost to Level-1.
level-2: Applies the cost to Level-2.
Usage guidelines
If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.
Examples
# Configure the Level-2 IS-IS cost as 5 for GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] isis cost 5 level-2
Related commands
• auto-cost enable
• bandwidth-reference
isis dis-name
NOTE:
This command does not take effect on a Point-to-Point interface.
Use isis dis-name to configure a name for a DIS to represent the pseudo node on a broadcast network.
Use undo isis dis-name to restore the default.
Syntax
isis dis-name symbolic-name
undo isis dis-name
Default
No name is configured for the DIS.
Views
Interface view
Predefined user roles
network-admin