R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

263
Views
IPv4 unicast topology view
Predefined user roles
network-admin
Usage guidelines
The routing management module maintains IS-IS IPv4 unicast topology view on the interface. This
command enables IS-IS in IPv4 unicast topology view on the interface.
To configure this command, you must complete the following tasks:
• Enable IS-IS on the interface.
• Create an IS-IS IPv4 unicast topology.
Examples
# Enable IS-IS for IS-IS IPv4 unicast topology voice on the interface.
<Sysname> system-view
[Sysname] isis 100
[Sysname-isis-100] address-family ipv4
[Sysname-isis-100-ipv4] topology voice tid 4000
[Sysname-isis-100-ipv4-topo-voice] quit
[Sysname-isis-100-ipv4] quit
[Sysname-isis-100] quit
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] isis enable 100
[Sysname-GigabitEthernet2/1/1] topology ipv4 voice
[Sysname-GigabitEthernet2/1/1-ipv4-topo-voice] isis topology enable
is-level
Use is-level to specify the IS level.
Use undo is-level to restore the default.
Syntax
is-level { level-1 | level-1-2 | level-2 }
undo is-level
Default
The IS level is level-1-2.
Views
IS-IS view
Predefined user roles
network-admin
Parameters
level-1: Specifies Level-1, which means IS-IS only calculates intra-area routes and maintains the Level-1
LSDB.