R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

265
is-name map
Use is-name map to configure a system ID to host name mapping for a remote IS.
Use undo is-name map to remove the mapping.
Syntax
is-name map sys-id map-sys-name
undo is-name map sys-id
Views
IS-IS view
Predefined user roles
network-admin
Parameters
sys-id: Specifies the system ID or pseudonode ID of a remote IS.
map-sys-name: Specifies a host name for the remote IS, a case-insensitive string of 1 to 64 characters.
Usage guidelines
Each remote IS system ID corresponds to only one name.
Examples
# Map the host name RUTB to the system ID 0000.0000.0041 of the remote IS.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] is-name map 0000.0000.0041 RUTB
Related commands
display isis name-table
ispf enable
Use ispf enable to enable IS-IS incremental SPF (ISPF).
Use undo ispf enable to disable IS-IS ISPF.
Syntax
ispf enable
undo ispf enable
Default
IS-IS ISPF is enabled.
Views
IS-IS IPv4 unicast address family view, IS-IS IPv4 unicast topology view
Predefined user roles
network-admin