R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

460
node 1 permit:
if-match acl 3999
Matched: 0
node 2 permit(no resource):
if-match acl 2000
apply next-hop 2.2.2.2
apply output-interface GigabitEthernet2/1/2 track 1 (down)
apply output-interface GigabitEthernet2/1/3 track 2 (inactive)
Matched: 0
node 5 permit:
if-match acl 3101
apply next-hop 1.1.1.1
Matched: 0 (no statistics resource)
Total matched: 0
Table 106 Command output
Field Description
Policy based routing information for
interface
GigabitEthernet2/1/1(failed)
PBR configuration and statistics on GigabitEthernet 2/1/1.
failed indicates that the policy (including all its nodes) failed to be
assigned to the driver.
node 0 deny(not support)
node 2 permit(no resource)
Match mode of the node, permit or deny.
not support means the device does not support match criteria configured
on the node. no resource means the device has insufficient ACL
resources, and failed to assign ACL resources to the node.
if-match acl Matches packets against the ACL.
apply next-hop Specify a next hop for permitted packets.
apply output-interface
GigabitEthernet2/1/2 track 1
(down)
Specify an output interface for permitted packets. The interface status
includes the following:
• up—The interface is up.
• down—The interface is down at network layer.
• inactive—The card that hosts the interface is not in position.
Matched: 0 (no statistics resource)
Number of successful matches on the node (no statistics resource
indicates insufficient statistics resources).
Total matched Total number of successful matches on all nodes.
Related commands
reset ip policy-based-route statistics
display ip policy-based-route local
Use display ip policy-based-route local to display local PBR configuration and statistics.
Syntax
MSR2000/MSR3000:
display ip policy-based-route local
MSR4000: