R0106-HP MSR Router Series Layer 3 - IP Routing Command Reference(V7)

539
Usage guidelines
When network changes are infrequent, LSAs are generated at the minimum-interval. If network changes
become frequent, the LSA generation interval is incremented by incremental-interval × 2
n-2
(n is the
number of generation times) for each generation until the maximum-interval is reached.
The minimum interval and the incremental interval cannot be greater than the maximum interval.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100 milliseconds,
and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] lsa-generation-interval 2 100 100
Related commands
lsa-arrival-interval
maximum load-balancing (OSPFv3 view)
Use maximum load-balancing to configure the maximum number of equal-cost multi-path (ECMP) routes.
Use undo maximum load-balancing to restore the default.
Syntax
maximum load-balancing maximum
undo maximum load-balancing
Default
The maximum number of ECMP routes is 32.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
maximum: Specifies the maximum number of ECMP routes, in the range of 1 to 32. When the maximum
number is 1, OSPFv3 does not perform load balancing.
Examples
# Configure the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] maximum load-balancing 2
non-stop-routing
Use non-stop-routing to enable OSPFv3 NSR.
Use undo non-stop-routing to disable OSPFv3 NSR.