R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

146
Ste
p
Command Remarks
2. Enter IS-IS IPv4 unicast
address family view or
IS-IS IPv4 unicast
topology view.
• Enter IS-IS IPv4 unicast address family view:
a. isis [ process-id ] [ vpn-instance
vpn-instance-name ]
b. cost-style { wide | wide-compatible }
c. address-family ipv4 [ unicast ]
• Enter IS-IS IPv4 unicast topology view:
d. isis [ process-id ] [ vpn-instance
vpn-instance-name ]
e. cost-style { wide | wide-compatible }
f. address-family ipv4 [ unicast ]
g. topology topo-name tid tid
Use either method.
3. Configure route leaking
from Level-1 to Level-2.
import-route isis level-1 into level-2 [ filter-policy
{ acl-number | prefix-list prefix-list-name |
route-policy route-policy-name } | tag tag ] *
By default, IS-IS advertises
routes from Level-1 to
Level-2.
4. Configure route leaking
from Level-2 to Level-1.
import-route isis level-2 into level-1 [ filter-policy
{ acl-number | prefix-list prefix-list-name |
route-policy route-policy-name } | tag tag ] *
By default, IS-IS does not
advertise routes from
Level-2 to Level-1.
Tuning and optimizing IS-IS networks
Configuration prerequisites
Before you tune and optimize IS-IS networks, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
• Enable IS-IS.
Specifying the interval for sending IS-IS hello packets
If a neighbor does not receive any hello packets from the router within the advertised hold time, it
considers the router down and recalculates the routes. The hold time is the hello multiplier multiplied by
the hello interval.
To specify the interval for sending hello packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify the interval for sending
hello packets.
isis timer hello seconds [ level-1 |
level-2 ]
The default setting is 10 seconds.
The interval between hello packets
sent by the DIS is 1/3 the hello
interval set with the isis timer hello
command.