R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

158
To configure IS-IS network management:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Bind MIB to an IS-IS
process.
isis mib-binding process-id
By default, MIB is bound to the IS-IS
process with the smallest process
ID.
3. Enable IS-IS
notification sending.
snmp-agent trap enable isis
[ adjacency-state-change | area-mismatch
| authentication | authentication-type |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-corrupt |
lsp-parse-error | lsp-size-exceeded |
manual-address-drop | max-seq-exceeded
| maxarea-mismatch | own-lsp-purge |
protocol-support | rejected-adjacency |
skip-sequence-number | version-skew ] *
By default, IS-IS notification
sending is enabled.
4. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
5. Configure the context
name for the SNMP
object for managing
IS-IS.
snmp context-name context-name
By default, no context name is set
for the SNMP object for managing
IS-IS.
Configuring IS-IS PIC
Prefix Independent Convergence (PIC) enables the device to speed up network convergence by ignoring
the number of prefixes.
When both IS-IS PIC and IS-IS FRR are configured, IS-IS FRR takes effect.
IS-IS PIC applies only to LSPs sent by neighbors.
Configuring IS-IS PIC
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Enable PIC for IS-IS.
pic [ additional-path-always ] By default, IS-IS PIC is enabled.
Configuring BFD for IS-IS PIC
By default, IS-IS PIC does not use BFD to detect primary link failures. To speed up IS-IS convergence,
enable BFD single-hop echo detection for IS-IS PIC to detect primary link failures.
To configure BFD for IS-IS PIC:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A