R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

225
Ste
p
Command Remarks
2. Enter BGP IPv6 unicast address
family view, BGP-VPN IPv6
unicast address family view, or
BGP IPv6 multicast address
family view.
• Enter BGP IPv6 unicast address
family view:
a. bgp as-number
b. address-family ipv6
[ unicast ]
• Enter BGP-VPN IPv6 unicast
address family view:
c. bgp as-number
d. ip vpn-instance
vpn-instance-name
e. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast
address family view:
f. bgp as-number
g. address-family ipv6
multicast
N/A
3. Inject a local network to the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ route-policy route-policy-name ]
By default, BGP does not advertise
any local network.
Redistributing IGP routes
Perform this task to configure route redistribution from an IGP to BGP.
By default, BGP does not redistribute default IGP routes. You can use the default-route imported
command to redistribute default IGP routes into the BGP routing table.
Only active routes can be redistributed. To view route state information, use the display ip routing-table
protocol or display ipv6 routing-table protocol command.
The ORIGIN attribute of BGP routes redistributed from IGPs is INCOMPLETE.
To configure BGP to redistribute IGP routes (IPv4 unicast/multicast address family):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A