R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

228
Ste
p
Command Remarks
3. Configure automatic route
summarization.
summary automatic
By default, automatic route
summarization is not configured.
Configuring manual route summarization
By configuring manual route summarization, you can do the following:
• Summarize both redistributed routes and routes injected using the network command.
• Determine the mask length for a summary route.
To configure BGP manual route summarization (IPv4 unicast/multicast address family):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP IPv4 unicast address
family view, BGP-VPN IPv4
unicast address family view, or
BGP IPv4 multicast address
family view.
• Enter BGP IPv4 unicast address
family view:
a. bgp as-number
b. address-family ipv4
[ unicast ]
• Enter BGP-VPN IPv4 unicast
address family view:
c. bgp as-number
d. ip vpn-instance
vpn-instance-name
e. address-family ipv4
[ unicast ]
• Enter BGP IPv4 multicast
address family view:
f. bgp as-number
g. address-family ipv4
multicast
N/A
3. Create a summary route in the
BGP routing table.
aggregate ip-address { mask |
mask-length } [ as-set |
attribute-policy route-policy-name
| detail-suppressed | origin-policy
route-policy-name |
suppress-policy
route-policy-name ] *
By default, no summary route is
configured.
To configure BGP manual route summarization (IPv6 unicast/multicast address family):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A