R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

270
Ste
p
Command Remarks
2. Enter BGP IPv4 unicast address
family view, BGP-VPN IPv4
unicast address family view, or
BGP IPv4 multicast address
family view.
• Enter BGP IPv4 unicast address
family view:
a. bgp as-number
b. address-family ipv4
[ unicast ]
• Enter BGP-VPN IPv4 unicast
address family view:
c. bgp as-number
d. ip vpn-instance
vpn-instance-name
e. address-family ipv4
[ unicast ]
• Enter BGP IPv4 multicast
address family view:
f. bgp as-number
g. address-family ipv4
multicast
N/A
3. Save all route updates from the
peer or peer group.
peer { group-name | ip-address }
keep-all-routes
By default, the routes are not
saved.
This command takes effect only for
the routes received after this
command is executed.
To save all route updates from the specified peer or peer group (IPv6 unicast/multicast address family):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP IPv6 unicast address
family view, or BGP IPv6
multicast address family view.
• Enter BGP IPv6 unicast address
family view:
a. bgp as-number
b. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast
address family view:
c. bgp as-number
d. address-family ipv6
multicast
N/A
3. Save all route updates from the
peer or peer group.
peer { group-name |
ipv6-address } keep-all-routes
By default, the routes are not
saved.
This command takes effect only for
the routes received after this
command is executed.
Configuring manual soft-reset
To configure manual soft-reset (IPv4 unicast/multicast address family):