R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)
344
# Configure Router C.
<RouterC> system-view
[RouterC] bgp 65009
[RouterC-bgp] router-id 3.3.3.3
[RouterC-bgp] group ebgp external
[RouterC-bgp] peer 3::1 as-number 65008
[RouterC-bgp] peer 3::1 group ebgp
[RouterC-bgp] address-family ipv6 unicast
[RouterC-bgp-ipv6] peer ebgp enable
[RouterC-bgp-ipv6] quit
[RouterC-bgp] quit
# Configure Router B.
[RouterB-bgp] group ebgp external
[RouterB-bgp] peer 3::2 as-number 65009
[RouterB-bgp] peer 3::2 group ebgp
[RouterB-bgp] address-family ipv6 unicast
[RouterB-bgp-ipv6] peer ebgp enable
[RouterB-bgp-ipv6] quit
[RouterB-bgp] quit
4. Configure IPsec transform sets and IPsec profiles:
# On Router A, create an IPsec transform set named tran1.
[RouterA] ipsec transform-set tran1
# Set the encapsulation mode to transport mode.
[RouterA-ipsec-transform-set-tran1] encapsulation-mode transport
# Set the security protocol to ESP, the encryption algorithm to DES, and authentication algorithm
to SHA1.
[RouterA-ipsec-transform-set-tran1] esp encryption-algorithm des
[RouterA-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[RouterA-ipsec-transform-set-tran1] quit
# Create an IPsec profile named policy001, and specify the manual mode for it.
[RouterA] ipsec profile policy001 manual
# Reference IPsec transform set tran1.
[RouterA-ipsec-profile-policy001-manual] transform-set tran1
# Set the SPIs of the inbound and outbound SAs to 12345.
[RouterA-ipsec-profile-policy001-manual] sa spi outbound esp 12345
[RouterA-ipsec-profile-policy001-manual] sa spi inbound esp 12345
# Set the keys for the inbound and outbound SAs using ESP to abcdefg.
[RouterA-ipsec-profile-policy001-manual] sa string-key outbound esp simple abcdefg
[RouterA-ipsec-profile-policy001-manual] sa string-key inbound esp simple abcdefg
[RouterA-ipsec-profile-policy001-manual] quit
# On Router B, create an IPsec transform set named tran1.
[RouterB] ipsec transform-set tran1
# Set the encapsulation mode to transport mode.
[RouterB-ipsec-transform-set-tran1] encapsulation-mode transport
# Set the security protocol to ESP, the encryption algorithm to DES, and authentication algorithm
to SHA1.