R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

351
Destination: 4::/64
Protocol: BGP4+ Process ID: 0
SubProtID: 0x2 Age: 00h00m58s
Cost: 0 Preference: 255
IpPre: N/A QosLocalID: N/A
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0xa OrigAs: 200
NibID: 0x25000003 LastAs: 200
AttrID: 0x3 Neighbor: 3001::2
Flags: 0x10060 OrigNextHop: 3001::2
Label: NULL RealNextHop: 3001::2
BkLabel: NULL BkNextHop: 2001::2
Tunnel ID: Invalid Interface: GigabitEthernet2/1/1
BkTunnel ID: Invalid BkInterface: GigabitEthernet2/1/2
FtnIndex: 0x0
# Display detailed information about the route to 1::/64 on Router D. The output shows the backup next
hop for the route.
[RouterD] display ipv6 routing-table 1:: 64 verbose
Summary Count : 1
Destination: 1::/64
Protocol: BGP4+ Process ID: 0
SubProtID: 0x1 Age: 00h03m24s
Cost: 0 Preference: 255
IpPre: N/A QosLocalID: N/A
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0xa OrigAs: 100
NibID: 0x25000003 LastAs: 100
AttrID: 0x4 Neighbor: 3002::1
Flags: 0x10060 OrigNextHop: 3002::1
Label: NULL RealNextHop: 3002::1
BkLabel: NULL BkNextHop: 2002::1
Tunnel ID: Invalid Interface: GigabitEthernet2/1/1
BkTunnel ID: Invalid BkInterface: GigabitEthernet2/1/2
FtnIndex: 0x0
IPv6 multicast BGP configuration example
Network requirements
As shown in Figure 83, AS 100 and AS 200 run OSPFv3 to ensure intra-AS connectivity, and run IPv6
MBGP to exchange IPv6 unicast routes used for RPF check.
Enable embedded RP on all routers in IPv6 PIM domains so that the receiver can receive multicast traffic
from the source.