R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

352
Figure 83 Network diagram
Table 15 Interface and IP address assignment
Device Interface IP address
Device Interface IP address
Source - 1002::100/64 Router C GE2/1/1 3002::1/64
Router A GE2/1/1 1002::1/64 S2/1/0 3001::1/64
POS2/1/0 1001::1/64 S2/1/1 2001::2/64
Router B POS2/1/0 1001::2/64 Router D S2/1/0 2002::2/64
S2/1/0 2001::1/64 S2/1/1 3001::2/64
S2/1/1 2002::1/64
Configuration procedure
1. Configure IPv6 addresses for interfaces and configure OSPFv3 in AS 200 to ensure intra-AS
connectivity. (Details not shown.)
2. Enable IPv6 multicast routing, IPv6 PIM-SM, and MLD, and configure BSR boundaries:
# On Router A, enable IPv6 multicast routing globally, and enable IPv6 PIM-SM on interfaces.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ipv6 pim sm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface pos 2/1/0
[RouterA-Pos2/1/0] ipv6 pim sm
[RouterA-Pos2/1/0] quit
# Configure Router B and Router D in the same way that Router A was configured.
# On Router C, enable IPv6 multicast routing globally.
<RouterC> system-view
[RouterC] ipv6 multicast routing
[RouterC-mrib6] quit
IPv6 MBGP peers
AS 100 AS 200
Source
Receiver
Router A Router B
Router CRouter D
POS2/1/0 POS2/1/0
S2/1/1 S2/1/0
GE2/1/1
IPv6 PIM-SM 1
IPv6 PIM-SM 2