R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)
ii
Configuring received/redistributed route filtering ····························································································· 33
Configuring a preference for RIP ························································································································· 33
Configuring RIP route redistribution ····················································································································· 33
Tuning and optimizing RIP networks ···························································································································· 34
Configuration prerequisites ·································································································································· 34
Configuring RIP timers ··········································································································································· 34
Configuring split horizon and poison reverse ···································································································· 35
Configuring the maximum number of ECMP routes ·························································································· 35
Enabling zero field check on incoming RIPv1 messages ·················································································· 36
Enabling source IP address check on incoming RIP updates ············································································ 36
Configuring RIPv2 message authentication ········································································································ 37
Specifying a RIP neighbor ···································································································································· 37
Configuring RIP network management ················································································································ 37
Configuring the RIP packet sending rate ············································································································ 38
Setting the maximum length of RIP packets ········································································································ 38
Configuring RIP GR ························································································································································ 39
Configuring BFD for RIP ················································································································································· 39
Configuring single-hop echo detection (for a directly connected RIP neighbor) ············································ 39
Configuring single-hop echo detection (for a specific destination) ·································································· 40
Configuring bidirectional control detection ········································································································ 40
Configuring RIP FRR ······················································································································································· 41
Configuration restrictions and guidelines ··········································································································· 41
Configuration prerequisites ·································································································································· 41
Configuration procedure ······································································································································ 41
Displaying and maintaining RIP ··································································································································· 42
RIP configuration examples ··········································································································································· 42
Configuring basic RIP ··········································································································································· 42
Configuring RIP route redistribution ····················································································································· 45
Configuring an additional metric for a RIP interface ························································································· 47
Configuring RIP to advertise a summary route ··································································································· 49
Configuring BFD for RIP (single-hop echo detection for a directly connected neighbor) ······························ 52
Configuring BFD for RIP (single-hop echo detection for a specific destination)·············································· 54
Configuring BFD for RIP (bidirectional control detection) ················································································· 57
Configuring RIP FRR ·············································································································································· 61
Configuring OSPF ······················································································································································ 63
Overview ········································································································································································· 63
OSPF packets ························································································································································· 63
LSA types ································································································································································ 64
OSPF areas ···························································································································································· 64
Router types ···························································································································································· 66
Route types ····························································································································································· 67
Route calculation ··················································································································································· 68
OSPF network types ·············································································································································· 68
DR and BDR ··························································································································································· 68
Protocols and standards ······································································································································· 69
OSPF configuration task list ·········································································································································· 70
Enabling OSPF ······························································································································································· 71
Configuration prerequisites ·································································································································· 71
Configuration guidelines ······································································································································ 71
Enabling OSPF on a network ······························································································································· 72
Enabling OSPF on an interface ··························································································································· 72
Configuring OSPF areas ··············································································································································· 73
Configuring a stub area ······································································································································· 73
Configuring an NSSA area ·································································································································· 74