R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

414
• If a virtual link and area 0 each have an IPsec profile configured, the virtual link uses its own IPsec
profile.
To apply an IPsec profile to an area:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter OSPFv3 area view.
area area-id N/A
4. Apply an IPsec profile to the
area.
enable ipsec-profile profile-name
By default, no IPsec profile is
applied.
To apply an IPsec profile to an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPsec profile to the
interface.
ospfv3 ipsec-profile profile-name
By default, no IPsec profile is
applied.
To apply an IPsec profile to a virtual link:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter OSPFv3 area view.
area area-id N/A
4. Apply an IPsec profile to a
virtual link.
vlink-peer router-id [ dead seconds | hello
seconds | instance instance-id | retransmit
seconds | trans-delay seconds |
ipsec-profile profile-name ] *
By default, no IPsec profile is
applied.
Displaying and maintaining OSPFv3
Execute display commands in any view.
Pur
p
ose Command
Display information about the routes to
OSPFv3 ABR and ASBR.
display ospfv3 [ process-id ] abr-asbr
Display summary route information on
the OSPFv3 ABR.
display ospfv3 [ process-id ] [ area area-id ] abr-summary
[ ipv6-address prefix-length ] [ verbose ]
Display OSPFv3 process information. display ospfv3 [ process-id ] [ verbose ]
Display OSPFv3 GR information. display ospfv3 [ process-id ] graceful-restart