R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

429

Figure 98 Network diagram

Configuration procedure

1. Configure IPv6 addresses for interfaces. (Details not shown.)

2. Configure basic OSPFv3:

# On Router A, enable OSPFv3 process 1, enable GR, and set the router ID to 1.1.1.1.

<RouterA> system-view

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] graceful-restart enable

[RouterA-ospfv3-1] quit

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] ospfv3 1 area 1

[RouterA-GigabitEthernet2/1/1] quit

# On Router B, enable OSPFv3 and set the router ID to 2.2.2.2. (By default, GR helper is enabled

on a router.)

<RouterB> system-view

[RouterB] ospfv3 1

[RouterB-ospfv3-1] router-id 2.2.2.2

[RouterB-ospfv3-1] quit

[RouterB] interface gigabitethernet 2/1/1

[RouterB-GigabitEthernet2/1/1] ospfv3 1 area 1

[RouterB-GigabitEthernet2/1/1] quit

# On Router C, enable OSPFv3 and set the router ID to 3.3.3.3. (By default, GR helper is enabled

on a router.)

<RouterC> system-view

[RouterC] ospfv3 1

[RouterC-ospfv3-1] router-id 3.3.3.3

[RouterC-ospfv3-1] quit

[RouterC] interface gigabitethernet 2/1/1

[RouterC-GigabitEthernet2/1/1] ospfv3 1 area 1

[RouterC-GigabitEthernet2/1/1] quit