R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

432
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ospfv3 1 area 0
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] ospfv3 1 area 0
[RouterA-GigabitEthernet2/1/2] quit
# Enable OSPFv3 and set the router ID to 2.2.2.2 on Router B.
<RouterB> system-view
[RouterB] ospfv3 1
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] ospfv3 1 area 0
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] ospfv3 1 area 0
[RouterB-GigabitEthernet2/1/2] quit
# Enable OSPFv3 and set the router ID to 3.3.3.3 on Router C.
<RouterC> system-view
[RouterC] ospfv3 1
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] ospfv3 1 area 0
[RouterC-GigabitEthernet2/1/1] quit
[RouterC] interface gigabitethernet 2/1/2
[RouterC-GigabitEthernet2/1/2] ospfv3 1 area 0
[RouterC-GigabitEthernet2/1/2] quit
3. Configure BFD:
# Enable BFD and configure BFD parameters on Router A.
[[RouterA] bfd session init-mode active
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ospfv3 bfd enable
[RouterA-GigabitEthernet2/1/1] bfd min-transmit-interval 500
[RouterA-GigabitEthernet2/1/1] bfd min-receive-interval 500
[RouterA-GigabitEthernet2/1/1] bfd detect-multiplier 7
[RouterA-GigabitEthernet2/1/1] return
# Enable BFD and configure BFD parameters on Router B.
[RouterB] bfd session init-mode active
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] ospfv3 bfd enable
[RouterB-GigabitEthernet2/1/1] bfd min-transmit-interval 500
[RouterB-GigabitEthernet2/1/1] bfd min-receive-interval 500
[RouterB-GigabitEthernet2/1/1] bfd detect-multiplier 6