R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

434

Figure 101 Network diagram

Configuration procedure

1. Configure IPv6 addresses for interfaces. (Details not shown.)

2. Configure OSPFv3 basic functions:

# On Router A, enable OSPFv3 and configure the router ID as 1.1.1.1.

<RouterA> system-view

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] quit

[RouterA] interface gigabitethernet 2/1/2

[RouterA-GigabitEthernet2/1/2] ospfv3 1 area 1

[RouterA-GigabitEthernet2/1/2] quit

# On Router B, enable OSPFv3 and configure the router ID as 2.2.2.2.

<RouterB> system-view

[RouterB] ospfv3 1

[RouterB-ospfv3-1] router-id 2.2.2.2

[RouterB-ospfv3-1] quit

[RouterB] interface gigabitethernet 2/1/1

[RouterB-GigabitEthernet2/1/1] ospfv3 1 area 0

[RouterB-GigabitEthernet2/1/1] quit

[RouterB] interface gigabitethernet 2/1/2

[RouterB-GigabitEthernet2/1/2] ospfv3 1 area 1

[RouterB-GigabitEthernet2/1/2] quit

# On Router C, enable OSPFv3 and configure the router ID as 3.3.3.3.

<RouterC> system-view

[RouterC] ospfv3 1

[RouterC-ospfv3-1] router-id 3.3.3.3

[RouterC-ospfv3-1] quit

[RouterC] interface gigabitethernet 2/1/1

[RouterC-GigabitEthernet2/1/1] ospfv3 1 area 0

[RouterC-GigabitEthernet2/1/1] quit

3. Configure OSPFv3 IPsec profiles:

{ On Router A:

# Create an IPsec transform set named trans.