R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

439
Ste
p
Command Remarks
8. Enable IPv6 for an IS-IS
process on the interface.
isis ipv6 enable [ process-id ]
By default, IPv6 is disabled for an
IS-IS process on the interface.
Configuring IPv6 IS-IS route control
Before you configure IPv6 IS-IS route control, complete basic IPv6 IS-IS configuration.
To configure IPv6 IS-IS route control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Enter IS-IS IPv6 address
family view.
address-family ipv6 [ unicast ] N/A
4. Specify a preference for
IPv6 IS-IS routes.
preference { route-policy route-policy-name |
preference } *
By default, the preference
for IPv6 IS-IS routes is 15.
5. Configure an IPv6 IS-IS
summary route.
summary ipv6-prefix prefix-length
[ avoid-feedback | generate_null0_route |
[ level-1 | level-1-2 | level-2 ] | tag tag ] *
By default, no IPv6 IS-IS
summary route is
configured.
6. Generate an IPv6 IS-IS
default route.
default-route-advertise [ avoid-learning |
[ level-1 | level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
By default, no IPv6 default
route is generated.
7. Configure IPv6 IS-IS to filter
redistributed routes.
filter-policy { acl6-number | prefix-list
prefix-list-name | route-policy
route-policy-name } export [ protocol
[ process-id ] ]
By default, IPv6 IS-IS does
not filter redistributed
routes.
This command is usually
used together with the
import-route command.
8. Configure IPv6 IS-IS to filter
received routes.
filter-policy { acl6-number | prefix-list
prefix-list-name | route-policy
route-policy-name } import
By default, IPv6 IS-IS does
not filter received routes.
9. Configure IPv6 IS-IS to
redistribute routes from
another routing protocol.
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost cost |
[ level-1 | level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
By default, IPv6 IS-IS does
not redistribute routes from
any other routing protocol.
10. Configure the maximum
number of redistributed
Level 1/Level 2 IPv6 routes.
import-route limit number
The following are default
settings for different routers:
• 200000 for MSR2000.
• 200000 for MSR3012
• 500000 for
MSR3024/MSR3044/
MSR3064.
• 1000000 for MSR4000