R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

472
Ste
p
Command Remarks
5. Match BGP routes whose
COMMUNITY attribute matches
a specified community list.
if-match community
{ { basic-community-list-number |
name comm-list-name }
[ whole-match ] |
adv-community-list-number }&<1-32>
By default, no COMMUNITY
match criterion is matched.
6. Match routes having the specified
cost.
if-match cost value
By default, no cost match
criterion is configured.
7. Match BGP routes whose
extended community attribute
matches a specified extended
community list.
if-match extcommunity
ext-comm-list-number&<1-32>
By default, no extended
community list match criterion
is configured.
8. Match routes having the specified
output interface.
if-match interface { interface-type
interface-number }&<1-16>
By default, no output interface
match criterion is configured.
This command is not
supported by BGP.
9. Match BGP routes having the
specified local preference.
if-match local-preference preference
By default, no local
preference is configured for
BGP routes.
10. Match MAC addresses in EVI
IS-IS packets.
if-match mac-list mac-list-name
By default, no MAC list match
criterion is configured.
11. Match routes having MPLS labels.
if-match mpls-label
By default, no MPLS label
match criterion is configured.
12. Match routes having the specified
route type.
if-match route-type { external-type1 |
external-type1or2 | external-type2 |
internal | is-is-level-1 | is-is-level-2 |
nssa-external-type1 |
nssa-external-type1or2 |
nssa-external-type2 } *
By default, no route type
match criterion is configured.
13. Match RIP, OSPF, and IS-IS routes
having the specified tag value.
if-match tag value
By default, no tag match
criterion is configured.
14. Match VLANs in EVI IS-IS
packets.
if-match vlan vlan-list
By default, no VLAN match
criterion is configured.
Configuring apply clauses
Except for the apply commands used for setting the next hop for IPv4 and IPv6 routes, all apply
commands are the same for IPv4 and IPv6 routing.
To configure apply clauses:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter routing policy node view.
route-policy route-policy-name
{ deny | permit } node
node-number
N/A
3. Set the AS_PATH attribute for
BGP routes.
apply as-path
as-number&<1-32> [ replace ]
By default, no AS_PATH attribute is
set for BGP routes.