R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

474
Ste
p
Command Remarks
20. Set a backup link for fast reroute
(FRR).
• apply fast-reroute
{ backup-interface
interface-type
interface-number
[ backup-nexthop
ip-address ] |
backup-nexthop
ip-address }
• apply ipv6 fast-reroute
backup-nexthop
ipv6-address
Use either command.
By default, no backup link is set for
FRR.
Configuring the continue clause
Follow these guidelines when you configure the continue clause to combine multiple nodes:
• If you configure an apply clause that sets different attribute values on all the nodes, the apply clause
on the node configured most recently takes effect.
• If you configure one the following apply clauses on all the nodes, the apply clause on each node
takes effect:
{ apply as-path without the replace keyword.
{ apply cost with the + or – keyword.
{ apply community with the additive keyword.
{ apply extcommunity with the additive keyword.
• The apply comm-list delete clause configured on the current node cannot delete the community
attributes set by the apply community clauses of the preceding nodes.
To configure the continue clause:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter routing policy node view.
route-policy route-policy-name
{ deny | permit } node node-number
N/A
3. Specify the next node to be
matched.
continue [ node-number ]
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.
Displaying and maintaining the routing policy
Execute display commands in any view and reset commands in user view.
Task Command
Display BGP AS path list information. display ip as-path [ as-path-number ]