R0106-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V7)

475
Task Command
Display BGP community list information.
display ip community-list [ basic-community-list-number |
adv-community-list-number | name comm-list-name ]
Display BGP extended community list
information.
display ip extcommunity-list [ ext-comm-list-number ]
Display IPv4 prefix list statistics. display ip prefix-list [ name prefix-list-name ]
Display IPv6 prefix list statistics. display ipv6 prefix-list [ name prefix-list-name ]
Display MAC list statistics. display mac-list [ name mac-list-name ]
Display routing policy information. display route-policy [ name route-policy-name ]
Clear IPv4 prefix list statistics. reset ip prefix-list [ prefix-list-name ]
Clear IPv6 prefix list statistics. reset ipv6 prefix-list [ prefix-list-name ]
Clear MAC list statistics. reset mac-list [ mac-list-name ]
Routing policy configuration examples
Applying a routing policy to IPv4 route redistribution
Network requirements
As shown in Figure 108, Router B exchanges routing information with Router A by using OSPF and with
Router C by using IS-IS.
Configure Router B to redistribute IS-IS routes into OSPF, and use a routing policy to set the cost of route
172.17.1.0/24 to 100 and the tag of route 172.17.2.0/24 to 20.
Figure 108 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IS-IS:
# Configure Router C.
<RouterC> system-view
[RouterC] isis